Well, I typed about a 10 paragraph post but, somehow, lost it. Not very happy. So, I will need to give the smaller version.

First, is it the 800 or 800II? I didn't think they made the 800s anymore.

Second with printer paper in the printer, turn it off, press on the button in the small recessed area in the front of the printer, and turn on the printer. This will cause the printer to print out a complete configuration. Look at the very bottom and see if the network setting are listed.

I will include a link to quite a bit of info and software. This may allow you to configure an IP. The best way is to allow it to obtain an IP address via DHCP if you have it on in your router or on your server. If it is on, then the printer should already have an IP.

You don't configure the printer using any of the software or a browser. You can see some info using a browser and the IP and see the network settings with the username and password of "root" and "public" but there is almost no information that way.

Instead you use print driver to create your settings. After Add Printer, you use the IP address to make a port, and after install, select printer properties to set everything the correct way. After this, go to AC admin section and ensure it is set up correctly.

cbaldwin@starmicronics.com_remove. If you need support from TSP, email Christine. She will make sure it is set up for you. I would definitely mention my name and business.

The software and documentation is here


Bert
Pediatrics
Brewer, Maine